3/8'' Nut Driver, Hollow Shaft, Insulated
630-3/8-INS
- Individually tested to exceed the IEC 60900 and ASTM F1505 standards for insulated tools, and clearly marked with the official 1,000-volt rating symbol.
- Two layers of insulation provide protection against electric shock.
- Thick, exceptionally tough, high-dielectric white inner coating is bonded to the tool.
- A flame retardant, impact-resistant, bright-orange outer coating.
- Hollow shafts make it possible to work on stacked circuit boards or other long-bolt applications.
- Tip-Ident quickly identifies nut driver size.
- Cushion-Grip™ handles for greater torque and comfort.
Videos
Images
High-Res JPG
630-7-16-ins_photo.jpg
Protect yourself when working near a live electrical source with Klein's insulated hollow-shaft nut driver. Clearly marked with the official 1,000-volt rating symbol, Klein insulated tools exceed IEC 60900 and ASTM F1505 standards for insulated tools. Two layers of insulation provide protection against electric shock. The full hollow shaft permits turning nuts on long screws.
Specifications
Application:
For working close to live electrical circuits
Handle Type:
Double Insulation
Hex Size:
3/8''
Overall Length:
6-3/4'' (171 mm)
Shank Length:
3'' (76 mm)
Special Features:
The full hollow-shaft shank permits turning nuts on long screws.
UPC:
092644650598
Additional Information
Warnings
- Only use tools that are marked with the official international 1,000-volt rating symbol shown above, if there is any chance that the tools will make contact with a live electrical source.
- Whenever possible, always switch off lines and equipment prior to working on or around them. Klein insulated tools are designed only to reduce the chance of injury where the tool may make contact with a live source.
- Do NOT touch uninsulated portion of the tool or any conductive object when either might contact a live electrical source.
- Wear approved eye protection.
- Because moisture, films or other surface contaminants are conductive, Klein insulated tools must be kept clean, dry and free from any surface contaminants.
- Always inspect your tools before use. Destroy tool if insulation becomes damaged in any way.
